Shop

Oxoid Salmonella Rapid Test Elective Medium (SRTEM) is a selective enrichment broth medium specifically formulated for use with the Oxoid Salmonella Rapid Test Kit, Part No. FT0201A.

Salmonella Rapid Test Elective Medium (SRTEM), Oxoid Composition

Salmonella Rapid Test Elective Medium (SRTEM), Oxoid Preparation:
Add 61g to 1 litre of distilled water (double strength medium). Sterilize by autoclaving at 121°C for 15 minutes. Cool to 18-25°C and use as described in the Oxoid Salmonella Rapid Test (Code FT0201) instruction leaflet.

Storage conditions and Shelf life
Store the dehydrated medium at 10-30°C and use before the expiry date on the label.
Store the prepared medium at room temperature.

Oxoid Salmonella Selective Supplement is used for the presumptive identification of Salmonella species from clinical and food samples.

• Add to Chromogenic Salmonella Agar Base, Part No. CM1007B or Brilliance™ Salmonella Agar Base, Part No. CM1092B
• Each vial supplements 500mL of medium

Salmonella Selective Supplement, Oxoid Composition

Chromogenic Salmonella Agar, Oxoid Preparation:
Suspend 25g in 500ml of distilled water and add the contents of one vial of Salmonella Selective Supplement (SR0194) reconstituted as directed. Mix well and bring to the boil with frequent agitation. DO NOT AUTOCLAVE. DO NOT HOLD AT BOILING TEMPERATURE. Cool to 50°C, mix well and pour into sterile Petri dishes.

Brilliance Salmonella Agar, Oxoid Preparation:
Suspend 27g of Brilliance Salmonella Agar Base in 500ml of distilled water. Add the contents of 1 vial of Salmonella Selective Supplement, resuspended as directed. Mix well and sterilise by bringing to the boil with frequent agitation. Cool to around 50ºC, mix well and pour into sterile Petri dishes.
NOTE: It is critical that the selective supplement is added prior to heating. When preparing volumes greater than 1 litre contact Oxoid Technical Support for directions.

Storage conditions and Shelf life
Salmonella Selective Supplement should be stored in the dark at 2-8ºC. When stored as directed, the un-opened products will remain stable until the expiry date printed on the packaging.

Enrich and isolate halophilic organisms, especially staphylococci, using Thermo Scientific™ Oxoid™ Salt Meat Broth Tablets. Salt Meat Broth Tablets are specially designed for the isolation of staphylococci from grossly contaminated specimens such as feces, particularly during the investigation of staphylococcal food poisoning. The medium is highly sensitive as it can detect even low numbers of staphylococci from samples having large proportions of heterogeneous microbial flora.^1,2

• Quantity: 100 tablets/bottle

Salt Meat Broth Tablets, Oxoid Composition

Salt Meat Broth, Oxoid Preparation:
Add 2 tablets to 10ml of distilled water in an appropriately sized test tube and soak for 5 minutes. Sterilise by autoclaving at 121°C for 15 minutes.

Storage conditions and Shelf life
Store the dehydrated medium at 10-30°C and use before the expiry date on the label.
Store the prepared medium at room temperature.

Grow and isolate aerobic and anaerobic organisms of the intestinal tract, which may require selective conditions to inhibit the growth of background organisms like Escherichia coli, with Thermo Scientific™ Oxoid™ Schaedler Anaerobe Agar. The presence of cysteine in the medium provides selectivity against Escherichia coli as cysteine has shown to have inhibitory effects on several enzymatic reactions of Escherichia coli in vitro.¹

Schaedler Anaerobe Agar, Oxoid Composition

Schaedler Anaerobe Agar, Oxoid Preparation:
Suspend 40g in 1 litre of distilled water and boil to dissolve the medium completely. Sterilise by autoclaving at 121°C for 15 minutes. Mix well before pouring.

Storage conditions and Shelf life
Store the dehydrated medium at 10-30°C and use before the expiry date on the label.
Prepared plates may be stored at 2-8°C if suitably protected.

• Oxoid Schaedler Anaerobe Broth is a thioglycollate-free broth for the general growth of anaerobes.
• For use in blood cultures and antibiotic MIC studies.

Schaedler Anaerobe Broth, Oxoid Composition

Schaedler Anaerobe Broth, Oxoid Preparation:
Add 26.5g to 1 litre of distilled water and mix to dissolve completely. Dispense into final containers and sterilise by autoclaving at 121°C for 15 minutes.

Storage conditions and Shelf life
Store the dehydrated medium at 10-30°C and use before the expiry date on the label.
Store prepared broth in the dark at <15°C.

Precautions
As with all anaerobic broth media, it is important to avoid chemo-oxidation (overheating) and photo-oxidation (storage in the light) because such oxidative effects cause the inhibition of growth.

Enrich and isolate Salmonella from feces and food products with Thermo Scientific™ Oxoid™ Selenite Broth Base (Lactose).The presence of Selenium in the medium provides selectivity against non-target bacteria.

Selenite Broth Base (Lactose), Oxoid Composition

Selenite Broth Base (Lactose), Oxoid Preparation:
Dissolve 4g of sodium biselenite LP0121 in 1 litre of distilled water and then add 19g of Selenite Broth Base. Warm to dissolve, mix well and fill out into containers. Sterilise in a boiling water bath, or in free flowing steam, for 10 minutes. DO NOT AUTOCLAVE.

To minimise any possible risk of teratogenicity to laboratory workers, the sodium biselenite must be added as a solution to this medium.
Robertson1 reported miscarriages and possible teratogenic effects on pregnant laboratory assistants which may have been caused by ingested sodium biselenite. Oxoid therefore removed this substance from the powdered medium.

Although no further reports have been received sodium biselenite is now considered to be very toxic and should be handled with great care.

Storage conditions and Shelf life
Store the dehydrated medium at 10-30°C and use before the expiry date on the label.
Store the prepared medium at 2-8°C away from light.

Precautions
Discard the prepared medium if large amounts of reduced selenite can be seen as a red precipitate in the bottom of the bottles.
Do not incubate longer than 24 hours because the inhibitory effect of selenite is reduced after 6-12 hours incubation.
Take sub-cultures of broth from the upper third of the broth column, which should be at least 5 cm in depth.

Enrich and improve the isolation of salmonellae from feces and food samples with Thermo Scientific™ Oxoid™ Selenite Cystine Broth Base. This modified medium is based upon the formulation described by Leifson with added cystine.

Selenite Cystine Broth Base, Oxoid Composition

Selenite Cystine Broth, Oxoid Preparation:
Dissolve 4g of sodium biselenite LP0121 in 1 litre of distilled water and then add 19g of Selenite Cystine Broth Base. Warm to dissolve and dispense into containers. Sterilise by placing in free flowing steam for 15 minutes. DO NOT AUTOCLAVE.

Robertson reported miscarriages and possible tetragenic effects on pregnant laboratory workers which may have been caused by the ingestion of sodium biselenite. To minimise any possible risk of teratogenicity to laboratory workers the sodium biselenite is not included in the dry powder but should be prepared separately as a solution to which the Selenite Cystine Broth Base is added.

Storage conditions and Shelf life
Store the dehydrated medium at 10-30°C and use before the expiry date on the label.
Store the prepared medium at 2-8°C away from light.

Precautions
Observe the precautionary comments made about sodium biselenite in Selenite Broth Base CM0395.
Discard the prepared medium if large amounts of reduced selenite can be seen as a red precipitate in the bottom of the bottle.
Do not incubate longer than 24 hours because the inhibitory effect of selenite is reduced after 6-12 hours incubation.
Take subcultures of broth from the upper third of the broth column which should be at least 5 cm in depth.

This product has been discontinued. The alternative to this product is Sensitest Agar, 500g.

A medium specially designed to give large, clear zones with all antibiotics, without the addition of lysed or whole blood.

Sensitest Agar, Oxoid Composition

Sensitest Agar, Oxoid Preparation:
Suspend 32g in 1 litre of distilled water and bring to the boil to dissolve the agar. Sterilise by autoclaving at 121°C for 15 minutes.

Storage conditions and Shelf life
Store the dehydrated medium at 10-30°C and use before the expiry date on the label.
Store the prepared plates of agar at 2-8°C.

Precautions
As with other susceptibility testing media, Sensitest Agar should be used for rapidly growing aerobic organisms only. It should not be modified by the addition of carbohydrates or incubated in a CO2 enriched atmosphere.
If the medium is used for Bell’s CDS method then the specified discs and technique must be used. Refer to the monograph cited in the References.

A medium specially designed to give large, clear zones with all antibiotics, without the addition of lysed or whole blood.

Sensitest Agar, Oxoid Composition

Sensitest Agar, Oxoid Preparation:
Suspend 32g in 1 litre of distilled water and bring to the boil to dissolve the agar. Sterilise by autoclaving at 121°C for 15 minutes.

Storage conditions and Shelf life
Store the dehydrated medium at 10-30°C and use before the expiry date on the label.
Store the prepared plates of agar at 2-8°C.

Precautions
As with other susceptibility testing media, Sensitest Agar should be used for rapidly growing aerobic organisms only. It should not be modified by the addition of carbohydrates or incubated in a CO2 enriched atmosphere.
If the medium is used for Bell’s CDS method then the specified discs and technique must be used. Refer to the monograph cited in the References.